固体除氟剂 SGR-0629 可出口 采购详情与询价入口

我们的实力 产品描述 联系我们 产品介绍 本产品主要 解决工业含氟废水的深度除氟，总氟需要处理到 1.0mg/L以下，使用石灰或氯化钙无法达标的情况。 可应用于煤化工、矿井废水、循环冷却水、电解铝、电子、电镀、光伏、玻璃等多个行业的氟化物去除。

性能指标 产品外观 橘黄色粉末 PH（1%水溶液） 2-5 使用方法 工业低含氟废水进入除氟反应池，加入高效除氟剂 SGR-0628,按每升水中氟离子1mg/L: 0.2-0.25克SGR-0628比例配量使用，具体用量根据实验小试确定，开启混合搅拌10min，后进入PH调节池，投加液碱，调节PH至6.5-7.5左右，再充分搅拌一段时间，进入絮凝池，加入絮凝剂PAM，搅拌一段时间后，进入沉淀槽沉淀，上清液溢流氟离子可达标排放。 包装与贮运 (1)本品采用塑料桶 或罐车 包装，根据客户需要确定。

(2)本产品储存在阴暗、通风的库房，并远离火种和高温，库温不宜超过30℃。 (3)与易燃、可燃物、还原剂、酸类、碱类等物质分开存放，切忌混储。 (4)贮区应备有泄漏应急处理设备和合适的收容材料。 安全与防护 (1)避免吸入、食入，操作人员必须佩戴好防护眼镜、防酸碱手套、安全 帽，必要时要穿戴好防酸碱防护服。 (2)工作过程中不准进食、饮水，工作完毕用肥皂和清水洗手。 (3)装卸时防止碰撞，注意密封，防止包装及容器损坏。

(4)装卸过程中要禁止野蛮装卸，确保容器不泄露、不倒塌、不坠落、不损坏，防止装卸过程中溶液溅出伤人。

Product specification of solid defluorination agent SGR-0629 1. Product introduction This product mainly solves the deep defluorination of industrial fluorine-containing wastewater, the total fluorine needs to be treated below 1.0mg/L, and the use of lime or calcium chloride can not reach the standard. It can be used to remove fluoride in coal chemical industry, mine wastewater, circulating cooling water, electrolytic aluminum, electronics, electroplating, photovoltaic, glass and other industries. 2. Performance index Product appearance Orange powder PH (1% aqueous solution) 2-5 3. Usage The industrial low fluorine waste water enters the defluorination reaction pool, and the high efficiency defluorination agent SGR-0628 is added. The specific dosage is determined according to the ratio of 1mg/L: 0.2g SGR-0628 in each liter of water. The specific dosage is determined according to the experimental small-scale test, and then enter the PH regulating tank, add liquid alkali, adjust the PH to about 6.57.5, then fully stir for a period of time, enter the flocculation tank, and add the flocculant PAM. After stirring for a period of time, it goes into the sedimentation tank to precipitate, and the overflow of the supernatant can meet the discharge standard. 4. Packaging and storage and transportation (1)This product is packed in plastic buckets, 25Kg/ buckets, 1t/ buckets or determined according to customer needs. (2)This product is stored in a dark, ventilated warehouse, away from fire and high temperature, and the storage temperature should not exceed 30 ℃ . (3)Separate from flammable, combustible, reducing agents, acids, alkalis and other substances, do not mix storage. (4)The storage area shall be provided with emergency leakage handling equipment and suitable reception materials. 5. Safety and protection (1)To avoid inhalation and ingestion, operators must wear protective glasses, acid-and-alkali gloves, protective mouth masks and work caps, and wear protective clothing against acid and alkali if necessary. (2)Do not eat or drink in the course of work, pay attention to ventilation or local ventilation, and wash hands with soap and water after work. (3)Prevent collision during loading and unloading, pay attention to sealing, and prevent packaging and container damage. (4)Barbaric loading and unloading should be prohibited in the process of loading and unloading to ensure that the container does not leak, collapse, fall or damage, so as to prevent the solution from splashing and injuring during the loading and unloading process. 联系方式